Need help?Do you have a question about the DTS 624 and is the answer not in the manual?
General| Brand | DTS |
|---|---|
| Model | 624 |
| Category | Gate Opener |
| Language | English |
Procedure to manually operate the gate.
Instructions for mounting the rack to the gate.
Instructions for mounting limit switch actuators.
Connecting a low voltage transformer to the controller.
Connecting a 220V transformer located at the gate.
Details on the courtesy light output function.
Diagram for connecting IR beams to the PCB.
Requirement for IR beams on DTS624 motor.
Explanation of dipswitch functions for operation.
Specific dipswitch settings for programming.
Setting the operational run time and calibration.
Configuring the automatic closing feature.
Setting up the pedestrian opening function.
Procedure to reset the unit to factory defaults.
Adjusting the load setting for the motor.
Programming transmitters for full open operation.
Programming transmitters for pedestrian operation.
Erasing specific programmed transmitters.
Erasing all programmed transmitters.
List of available electronic features.
Operation in standard mode without specific functions.
How to change motor direction using dipswitch 2.
Details on the auto close feature's operation.
Overriding auto close for party mode.
Operation of the condominium/free exit loop.
How Passive Infra Red Access Control (PIRAC) mode functions.
Functionality of the slowdown feature.
Configuration and operation of the tamper alarm.
Wiring diagram for the siren output.
Wiring diagram for the alarm output.
Functionality of the anti-highjack security feature.
How to activate/deactivate holiday lockout mode.
Explanation of audio feedback codes for status and errors.
Explanation of LED status indicators on the PCB.
Information for identifying different PCB versions.
Note on IR beam option jumper settings for N/O or N/C.
Important note on intercom trigger output voltage.
Details on the 12V OUT voltage on the 512 PCB.
Reasons and actions for no response from controls.
Troubleshooting steps for when the gate fails to open.
Diagnosis for 4 quick beeps and no gate movement.
Diagnosis for 4 slow beeps and no gate movement.
Cause and action for a low charge rate.
Meaning of two long beeps upon initial startup.
Troubleshooting for when the gate opens but fails to close.
Issues related to the gate stopping or reversing during operation.
Troubleshooting for overload conditions or relay issues.
Causes for the gate not remaining in the open position.
How beam triggers affect gate reversal during opening.
Symptoms of partial opening/closing with specific beeps.
Issues with limit actuators failing to stop the gate.
Troubleshooting for the gate motor gears jumping on the rack.
Problems with manual release or gate jamming.
Gate behavior when a full open trigger is given.
Diagnosis for missing beeps when operating the override lever.
To Next Page
