Dual 1229 Q - Lubrication and Maintenance Guide; Recommended Lubricant Types

Fig.
30 Lubrication points above the chassis
Lubrication
Fig. 31 Lubrication points below the
chassis
All
bearings and sliding
points have been properly
lubricated during assembly.
Re—lubrication is normally
not necessary for about two
years since
all important
bearings (motor bearings)
are
provided with oil retai—
ners and sintered bearings.
Lubrication should be app—
lied sparingly. lt is of
primary
importance that no
oil or
grease should get
onto
the friction surfaces
of the drive
wheel, motor
pulley or, turntable, to
avoid slippage. For the same
reason, avoid
touching these
parts.
If lubricants ars
varied,
they may interact
chemically
and
break down. To avoid
this risk, we recommend
use
of the products below for
subsequent
lubrication:
High—adhesion oil
Renotac No. 342
BP oil Super
Vico—
statik 10 W/30
Shell
Alvania No. 2
Isoflex
POP
40
Wacker silicone
oil
AK 500 000
23