Dual ALB10 - Connection Descriptions

4
Note: Be sure to follow specific instructions included with your amplifier
installation kit (not included with this amplifier). The information below should be
used a general guideline only.
Power Wire (+12V)
•Disconnectnegativebatteryterminalbeforeproceeding.Consultaqualified
technician for instructions if you are unsure.
•Planwireroutingbeforecuttinganywirestolength.Beginbyroutingthepower
+12Vwirefromthebatterytotheamplifierlocation.Useagrommetwhen
runningwiresthroughthefirewallormetalopenings.Avoidrunningthepower
wirenearexistingvehiclewiringtopreventinducednoisefromenteringthe
audio system.
•Useextremecautionwhendrillingholestoavoiddamagingfuellinesor
existingvehiclewiring.
•The+12VwireMUSTbefusedwithin18"ofthebatteryforprotectionofthe
vehicle’selectricalsystem.
Ground Wire (GND)
•Theamplifiergroundwireshouldbeasshortaspossible.Chooseaclean
unpaintedsectionofmetalorthevehiclechassiswhenattachingtheground
connection. Be sure to clean the area of any dirt or grease.
Remote Turn-on Wire (REM)
•Theremoteturn-onwireconnectstotheheadunit'samplifierturn-onleador
otherswitched12voltsource.
Input Signal
•Theamplifier'sinputsignalconnectstotheheadunit'slowlevel(RCA)outputs.
CAUTION
•Neverrunanywiresunderneathoroutsidethevehicle.
Connection Descriptions
INSTALLATION