DUALSUN FLASH - Protection Against Indirect Lightning Strikes; Cleaning the Surface of the Modules; Decommissioning the PV Installation; Disassembling a PV Module

6. Decommissioning of the installation
Before any intervention on the device / installation, cut off the power supply and injection (via the appropriate
fuse or a general switch, for example) and prevent any recommissioning.
For any intervention involving dismantling of the controllers, make sure that the internal components are not
likely to cause a discharge of static electricity.
Removing a module [17]
Decommissioning of the installation [17]
6.1. Removing a module
If it is necessary to dismantle a module, the following procedure must be followed:
• Cut the electrical circuit upstream and downstream of the inverter.
• Risk of electric shock. For this, refer to the manufacturer's manual for the inverter / microinverter. For this it
may be necessary to use a particular disconnection tool. Separate the module from its support.
• Disconnect the electrical connectors.
• Disconnect the module grounding.
6.2. Waste treatment
When handling waste from a used DualSun system, the applicable regional and national regulations must be
observed.
DualSun is a PV Cycle member.
Installation, use, maintenance manual DualSun FLASH
17