3. Mechanical installation
Installing DualSun modules [8]
Assembly specifications [10]
CAUTION
The management and installation of DualSun panels and the equipment making up the com-
plete installation must be carried out by trained and qualified personnel. The system must be
assembled and operated in accordance with the instructions provided, in accordance with the
local and national health and safety, and risk prevention regulations.
During assembly and operation of the system, no unauthorized person may be on the
roof or around the installation.
3.1. Installing DualSun modules
DualSun panels can be installed both in portrait and in landscape.
DualSun does not provide the mounting system for fastening the modules on the roof: please refer to the instal-
lation instructions of the chosen mounting system, to install the modules whether for an integrated or for a su-
perimposed installation, in landscape or portrait.
NOTE
The list of mounting systems compatible with DualSun modules is available in the “Mounting
systems compatibility" document in our
online library
CAUTION
Even when solar radiation is low, the photovoltaic system produces direct current (DC). This
DC current flows from the module to the inverter, do not handle the module or connections
without protection.
The modules are qualified for use in class II and comply with standards IEC / EN 61215-2 and
IEC / EN 61730-1. These standards concern PV modules for use on buildings, or on ground
structures.
Artificially concentrated solar radiation must not be directed onto the module.
The frame thickness and the dimensions of the SPRING panel are identical to photovoltaic panels. It adapts
easily to photovoltaic mounting systems; however, it is necessary to ensure the positioning of the hoses in rela-
tion to the mounting system frame and to the roof covering surface.
Installation, use, maintenance manual DualSun FLASH
8
To Next Page
Loading...
