EasyManua.ls Logo

Dualtron X - Product Start-Up Sequence; Acceleration and Deceleration Control; Throttle Malfunction Precautions

Dualtron X
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10
Dualtron X User Manual
How to use the product
2) How to start
After tilting the kickstand, find a stable
position on the footrest and then hold the
handle grip comfortably.
Be careful not to raise your foot on the rear
fender and rear suspension.
Step 3. Stance for driving
Acceleration can be performed by using
the throttle of the instrument panel while
driving, and the deceleration or stop can
be performed by holding the brakes on the
handle.
Step 4. Acceleration and deceleration
Brake
To turn on the product, press the power button on
the instrument panel for 2 seconds to turn on the
instrument panel.
You can set the start mode, cruise mode, electronic
brakes, and ABS function.
When driving is finished, turn off the LCD panel and
turn off the light power.
* The power of the instrument panel will turn off
automatically after a few minutes of inactivity.
LED light button
Sub battery power button
Step 1. Turning on the main switch
Pressing the sub-battery power button on the
right side of the steering tube will energize
the handle.
At this time, when the top of the LED light
button is pressed, high power headlights and
steering tube lights are illuminated.
Step2. Turning on the LED lights
Before driving, be sure to check the folding part, the handle part,
folding knob,the part where the main fixing part of the product is fastened well.
You must check before board to prevent accidents, check the damage and the position of the
suspension fixing bolt which is connecting suspension arm and swing arm.
Throttle malfunction caution
Regardless of whether the throttle is operated or not, the motor sensor may continue to operate,
causing malfunctions such as sudden acceleration.
In this case, hold the brake lever to cancel the operation.
This phenomenon may be caused by corrosion of the throttling, immersion of the throttle,
disconnection of the magnet, broken off levers, or breakage of the spring.
Do not bounce the throttle lever strongly.
Index finger
throttle
Rear fender
Rear suspension
Kickstand

DANGER
WARNING
CAUTION
NOTICE
DANGER

Related product manuals