21
4. To light rotis burner only (standard on some
units):
a. Depress and turn rotis control knob to High.
b. Within 2 seconds rotate ignitor knob clockwise
1/2 turn to 1 full turn (3 to 6 clicks).
CAUTION:
Do not rotate knob counterclockwise.
Ignitor will make a clicking sound but will not
spark or light the burners.
c. Verify rotis burner has lit by visual inspection
of flame.
d. If rotis burner fails to light within 5 seconds,
turn gas off and wait 5 minutes before trying
to relight by spark or match. (See Fig. 15 and
Fig. 16)
If Rotary Ignition Fails to Light
If the rotary ignition fails to ignite the burner(s),
repeat the lighting procedures described on the grill
faceplate. Check to see that the wire from the electrode
to the ignitor has not been disconnected. Also see
Troubleshooting — Page 29. Match lighting access ports
are provided in the burner box. If for any reason the
ignitor system is inoperative, conventional lighting
procedures are explained below.
Match Lighting Your Grill
WARNING:
Make sure that the hood is in the full
open position any time you attempt to light your
grill. Failure to open the hood could lead to
delayed ignition resulting in bodily harm.
Follow the simple steps listed below to light your
grill, in the event your rotary ignition fails:
1. Turn main gas supply on:
a. If portable, at LP cylinder (tank).
b. If permanent installation, at manual gas
cutoff valve.
2. To light left burner:
a. Locate lighting hole on left side of casting.
b. Insert lighted match into lighting hole on left
side (wooden match or fireplace match is
preferred). (See Fig. 16)
c. Depress left burner control and turn to High.
d. Observe that the burner has ignited through the
lighting port or through the observation portal
on the front of the firebox.
3. To light right burner:
a. Locate lighting hole on right side of casting.
b. Insert lighted match into lighting hole on right
side (wooden match or fireplace match is
preferred). (See Fig. 16)
c. Depress right burner control and turn to High.
d. Observe that the burner has ignited through the
lighting port or through the observation portal
on the front of the firebox.
4. To light ROTIS-A-GRATE
®
burner (standard on
some units):
a. Place lighted match (fireplace match is
recommended) over center of burner.
(See Fig. 16)
b. Depress rotis burner control and turn to High.
c. Observe that the burner has ignited.
FIG.15
MAIN BURNERS
MATCH LIGHTING
PORT ON EACH
SIDE OF BOTTOM
CASTING
ROTARY
IGNITION
KNOB
MATCH LIGHTING
PORT ON EACH SIDE
OF BOTTOM CASTING
MATCH LIGHT
ROTIS-A-GRATE
®
BURNER HERE
FIG. 16
02/33
To Next Page
Loading...
