Subject to technical changes!
Information concerning noise emission measured according to
relevant standards:
Sound pressure level L
PA
= 84,7 dB(A)
Uncertainty K =3,0 dB(A)
Sound power level L
WA
= 96,59 dB(A)
Uncertainty K = 1,69 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Vibration a
h
(left/right) = 3,662/3,522 m/s
2
Vibration le-
vel in the seat, a
h
= 1,261 m/s
2
Uncertainty K = 1,5 m/s
2
Reduce noise generation and vibration to a minimum!
• Use only equipment that is in perfect condition.
• Maintain and clean the equipment regularly.
• Adopt your way of working to the equipment.
• Do not overload the equipment.
• Have the equipment checked if necessary.
• Switch off he equipment when not in use.
• Wear gloves.
When using the petrol lawn mower for extended periods,
vibration-induced circulatory problems may occur (white
finger disease).
We cannot give exact details about the duration of use in
this case because it is different for each individual.
The following factors can influence the condition:
• Circulatory problems in the user’s hands
• Low outside temperatures
• Extended periods of use
We therefore recommend you wear warm work gloves
and take regular breaks.
19. Before first use
Times of use
Please comply with statutory regulations, which may
vary from location to location.
Make sure that you are familiar with the controls and ope-
ration of the machine. In particular, the user must know
how the work tools and engine can be stopped quickly.
The machine must only be used by persons who have
read the instruction manual and are familiar with opera-
tion of the machine. The user should seek expert and
practical instruction prior to initial operation. The user
must receive instruction on safe use of the machine from
the vendor or another expert.
During this instruction, the user should be made aware
• that the utmost care and concentration are required for
working with the machine.
• that a ride-on mower which is sliding down a slope can-
not be brought under control by applying the brake.
The main causes for the loss of control over the rideon
mower include:
• inadequate adhesion of the wheels,
• driving too fast,
• inappropriate braking,
• incorrect use (sport events, etc.),
• inadequate knowledge of the effects associated with
ground conditions, especially on slopes (see section
„For your safety“, „Working on slopes“),
• incorrect attachment of loads and poor load distribu-
tion.
Check the fuel system (particularly visible parts such as
e.g. tank, tank cap, hose connections) before operating
the machine. In the event of any leaks or damage, do not
start the engine – fir hazard! Have the machine repaired
by a specialist dealer prior to operation.
Defective and all other worn or damaged parts must be
removed before using the machine. Replace any illegible
or damaged danger signs and warnings on the machine.
To Next Page
Loading...
