39
WARNING
Only use a safety petrol can. Do not smoke when refueling.
Remove any oil or petrol residues. Switch off the engine be-
fore refueling and allow the engine to cool down for a few
minutes.
Insert Battery
Open battery cap, then insert battry, close the cap（As figure
）
Before operating the riding mower, adjust the seat position to
ensure that your feet can step in the accelerator pedal or
brake pedal firmly.
To move the seat:
• Turn key to STOP position and set the parking brake.
• Sit in seat，Flip the seat adjustment lever in left orientation.
• While holding the lever, slide the seat to the desired posi-
tion.
• Release the lever and make sure the seat is lock in position
before operating the mower.
Engaging the parking brake
• Fully depress and hold the brake pedal, and depress the
parking brake at the same time. Or firstly depress the par-
king brake, then fully depress the brake pedal.
• Release the brake pedal.
• Release the parking pedal.
• Turn off the machine and take out the key.
• If you need to unlock the parking brake, depress the brake
pedal forcefully and hear a "click" or the parking brake pe-
dal bounces, indicating that the unlocking is successful.
Note: The mower starts,the brake in lock state,blade not
working, the engine will not shut down when person leaves
the seat. In any other case, once person leaves the
seat,the engine shut down.
Setting the cutting deck height
• Stop the mower and disengage blades.
• Turn key to STOP position and press the parking brake. •
To raise the cutting deck, grasp the deck height adjustment
lever, push left to disengage from slot, move toward the
back of the mower, then push right into slot to secure. • To
lower the cutting deck, grasp the deck height adjustment le-
ver, push left to disengage from slot, move toward the front
of the mower, then push right into slot to secure.
To Next Page
Loading...
