Headlight “smart” switch-off
This function allows you to reduce current
consumption from the battery by automatically
managing headlight switching-off. The device is
enabled in three instances:
- 1) When the key is turned from OFF to ON and
the engine is not started within 60 seconds, the
headlight is turned off and will be turned back on
next time you start the engine.
- 2) After the vehicle has been running with the
headlights on and the engine is stopped using the
RUN-STOP button on the RH switch.
In this case, 60 seconds after stopping the
engine, the headlight is turned off and will be
turned back on next time you start the engine.
- 3) While starting up the engine, the headlight is
turned off and back on as soon as the engine is
started.
Headlight “smart” switch-on
This function allows programmed activation of the
headlight even with the motorcycle off (Key-Off). The
instrument panel stays active for 60 seconds soon
after Key-Off, and the headlight can be switched on
by pressing switch (1, Fig 14) in position A "
" or B
" ".
During these 60 seconds, each time the button
(1, Fig 14) is pressed in position A "
" or B " ", the
instrument panel allows to activate the headlight for
30 seconds; each time the button is pressed, the
activation time will be added up, up to a maximum of
180 seconds, corresponding to pressing the button 1
for 6 times.
After the first time you press switch (1, Fig 14) in
position A "
" or B " ", the period of 30 seconds
starts, thus switching on the headlight. Further
switch-on time can be added only if you press the
switch again within these 30 seconds. If the 30
seconds have elapsed, no further time can be added,
and the instrument panel will switch off the headlight.
To reset this function, you must perform at least one
Key-On/ Key-Off cycle.
If there is a sudden battery cutoff while the function
is active, the instrument panel will disable the
73
To Next Page