Front brake lever
Pull in the lever (2) towards the twistgrip to operate
the front brake. The system is hydraulically operated
and you just need to pull the lever gently.
The control lever features a dial adjuster (3) for lever
distance from the twistgrip on handlebar adjustment.
To adjust it, keep lever (2) fully extended, and turn
knob (3), turning it in correspondence of one of the
four foreseen positions. Keep in mind that position
no. 1 corresponds to the maximum distance between
the lever and the twistgrip, whereas position no. 4
corresponds to the minimum distance.
Attention
Before using these controls, read the
instructions in "Moving off".
Attention
Set front clutch lever when motorcycle is
stopped.
To Next Page