DQS indicator
The instrument panel displays DQS status as
follows:
- if DQS is enabled, “DQS U-D” indication (both
and
- if DQS is disabled, “DQS “ indication;
- if the DQS system or the control unit is in fault,
the “Err” indication;
- if DQS is in reduced mode, “DQS”
indication is displayed flashing.
The DQS with up/down feature allows the rider to
and without using the clutch lever.
It includes a two-way microswitch - built in the lever
mechanism - that outputs a signal to the engine
control unit whenever the gearchange is operated.
The system works in a separate way for
and and combines the action on
ignition advance and injection, available in the
system, with controlled opening for
operation during
Here below are some tips that will ensure you
properly exploit this feature:
- The Ducati Quick takes the same lever
operation as with vehicle not equipped with the
Ducati Quick Ducati Quick is not
designed for automatically.
- For any request or
the rider has to move the
lever from its idle position in the desired
direction against the force of the spring through
a over-travel, then keep the lever in
this position until the is completed.
Once the has been completed, the
lever has to be fully released in order to allow
another acted by Ducati Quick If
the rider does not move the lever up to end
Lap Off
0
11:34
A.M.
Gear
km/h
N
SETTING MENU
TRIP 1
TOT km
1245
0.0 km
LO HI
RACE
RPM X 1000
10
9
8
7
6
5
4
3
2
1
11
12
13
14
15
ABS 3
DTC 2
DQS
OFF
Fig 23
72
To Next Page