EasyManua.ls Logo

Duke SUB-CP-TC48 - User Manual

Duke SUB-CP-TC48
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Installation and
Operation Manual
P/N 529109
REV B 10/16/2018
This manual is Copyright © 2018 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
CAUTION:
Please read this manual completely before attempting
to install, operate or service this equipment
TRI-CHANNEL COLD PAN
MODEL
SUBCPTC

Table of Contents

Questions and Answers

  • B
    Bryan OsbornAug 7, 2025
    Why is my Duke SUB-CP-TC48 cabinet getting too warm?
    • T
      Theresa NavarroAug 8, 2025
      If the Duke Cold Pan cabinet is getting too warm, there are several possible causes. First, ensure the unit is plugged in. The thermostat might be set too warm; adjust it to a higher number for a colder temperature. A stuck thermostat switch may also be the culprit, requiring replacement. Check the doors to ensure they are sealing properly, and replace any torn or damaged door gaskets. The evaporator or condenser fan motor might not be running, in which case you should check and repair or replace the motor. A dirty condenser coil or filter can also cause this issue, so clean them. Finally, a refrigerant leak could be the cause; find the leak, repair it, and recharge the system.
  • N
    Noah RichAug 23, 2025
    What to do if there is water in the bottom of my Duke SUB-CP-TC48 Cold Pan unit?
    • B
      briansandersAug 23, 2025
      If you find water in the bottom of your Duke Cold Pan unit, it's likely due to a plugged drain hose. Clear the drain hose to resolve this. Alternatively, the drain hose might be loose or disconnected from the drain pan; in this case, tighten or reconnect the drain hose.

Summary

Wire Diagram

Electrical Connections

Details on connecting the unit to the power source and required electrical standards.

Earthing Instructions

Guidelines for safely grounding the unit to prevent electrical shock.

Installation

Unit Placement and Adjustment

Guides on positioning and leveling the cold pan unit in a lineup.

Installation and Adjustment of End Glass (Adjacent Units)

Installation and Adjustment of End Glass (End of Lineup)

Adjusting Front Glass

Operation Instructions

General Operating Instructions

Steps and guidelines for correctly operating the cold pan.

Preventive Maintenance

Cleaning the Condenser Coil

Instructions and warnings for cleaning the condenser coil.

Troubleshooting

Duke SUB-CP-TC48 Specifications

General IconGeneral
BrandDuke
ModelSUB-CP-TC48
CategoryCold Pan
LanguageEnglish

Related product manuals