EasyManua.ls Logo

Duke SUB-CP-TC74 - User Manual

Duke SUB-CP-TC74
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Installation and
Operation Manual
P/N 529109
REV B 10/16/2018
This manual is Copyright © 2018 Duke Manufacturing Co. All rights reserved.
Reproduction without written permission is prohibited. Duke is a registered
trademark of the Duke Manufacturing Co.
CAUTION:
Please read this manual completely before attempting
to install, operate or service this equipment
TRI-CHANNEL COLD PAN
MODEL
SUBCPTC

Table of Contents

Questions and Answers

  • E
    Elizabeth PowellAug 6, 2025
    Why is my Duke SUB-CP-TC74 Cold Pan cabinet getting too warm?
    • M
      Matthew ReedAug 7, 2025
      If the Duke Cold Pan cabinet is getting too warm, there are several possible causes. First, ensure the unit is plugged in. The thermostat might be set too warm; adjust it to a higher number for a colder temperature. A stuck thermostat switch may also be the culprit, requiring replacement. Check the doors to ensure they are sealing properly, and replace any torn or damaged door gaskets. The evaporator or condenser fan motor might not be running, in which case you should check and repair or replace the motor. A dirty condenser coil or filter can also cause this issue, so clean them. Finally, a refrigerant leak could be the cause; find the leak, repair it, and recharge the system.
  • T
    Travis Rogers DDSAug 21, 2025
    What to do if there is water in the bottom of my Duke Cold Pan unit?
    • S
      shaun66Aug 21, 2025
      If you find water in the bottom of your Duke Cold Pan unit, it's likely due to a plugged drain hose. Clear the drain hose to resolve this. Alternatively, the drain hose might be loose or disconnected from the drain pan; in this case, tighten or reconnect the drain hose.

Summary

Electrical and Installation Guidelines

Electrical Connections

Details on connecting the unit to the power source and verifying voltage/phase.

Earthing Instructions

Procedure for grounding the unit to reduce electric shock risk.

External Equipontential Bonding Terminal

Information on the supplemental bonding terminal for export units.

Installation Codes and Standards

References to US, Canadian, and CE electrical and installation codes.

Wiring Diagram

Specifications

Inspection and Unpacking

Tools and Parts Needed for Installation

Installation - Unit Placement and Adjustment

Installation - End Glass Adjustment

Adjacent Units

Step-by-step guide for installing and adjusting end glass between adjacent units.

End of Lineup

Procedure for installing and adjusting end glass for units at the end of a lineup.

Installation - Adjusting Front Glass

Operation Instructions

General Information

Basic guidance for operating the unit, including cleaning before first use.

General Cleaning Instructions

Daily cleaning procedures using warm, soapy water and mild detergents.

Polyethylene Cutting Boards

Cleaning recommendations for polyethylene cutting boards.

General Operating Instructions

Steps for pre-chilling, setting the thermostat, and product loading.

Preventive Maintenance

Cleaning the Condenser Coil

Procedure and frequency for cleaning the condenser coil to prevent issues.

Troubleshooting

Duke SUB-CP-TC74 Specifications

General IconGeneral
BrandDuke
ModelSUB-CP-TC74
CategoryCold Pan
LanguageEnglish

Related product manuals