Duke SUB-CP-TC60 User Manual

16 pages

To Next Page

To Next Page

Page #1 background image

Loading...

Page #1 background image

Installation and

Operation Manual

P/N 529109

REV B 10/16/2018

This manual is Copyright © 2018 Duke Manufacturing Co. All rights reserved.

Reproduction without written permission is prohibited. Duke is a registered

trademark of the Duke Manufacturing Co.

CAUTION:

Please read this manual completely before attempting

to install, operate or service this equipment

TRI-CHANNEL COLD PAN

MODEL

SUBCPTC

Table of Contents

Questions and Answers:

S
snicholsAug 6, 2025
Why is my Duke Cold Pan cabinet getting too warm?
- S
  Suzanne BakerAug 7, 2025
  If the Duke Cold Pan cabinet is getting too warm, there are several possible causes. First, ensure the unit is plugged in. The thermostat might be set too warm; adjust it to a higher number for a colder temperature. A stuck thermostat switch may also be the culprit, requiring replacement. Check the doors to ensure they are sealing properly, and replace any torn or damaged door gaskets. The evaporator or condenser fan motor might not be running, in which case you should check and repair or replace the motor. A dirty condenser coil or filter can also cause this issue, so clean them. Finally, a refrigerant leak could be the cause; find the leak, repair it, and recharge the system.
L
Lynn SalazarAug 21, 2025
What to do if there is water in the bottom of my Duke SUB-CP-TC60 Cold Pan unit?
- S
  Sandra JohnstonAug 22, 2025
  If you find water in the bottom of your Duke Cold Pan unit, it's likely due to a plugged drain hose. Clear the drain hose to resolve this. Alternatively, the drain hose might be loose or disconnected from the drain pan; in this case, tighten or reconnect the drain hose.

Duke SUB-CP-TC60 Specifications

General

Brand	Duke
Model	SUB-CP-TC60
Category	Cold Pan
Language	English

Summary

Important Safety Instructions

General Safety Guidelines

Guidelines for safe operation, warnings, and cautions for using the equipment.

Electrical Safety and Grounding

Requirements for electrical shock hazards, grounding, connections, and installation codes.

Electrical Wire Diagram

Equipment Specifications

Dimensional and Capacity Specifications

Physical dimensions and capacity charts for various cold pan models.

Electrical and Refrigerant Data

Technical specifications for electrical requirements and refrigerant details.

Inspection and Unpacking

Tools and Parts for Installation

Installation Procedure

Unit Placement and Adjustment

Positioning and leveling the unit within a lineup.

End Glass Installation (Adjacent Units)

Steps for installing end glass between adjacent cold pan units.

End Glass Installation (End of Lineup)

Steps for installing end glass at the end of a unit lineup.

Front Glass Adjustment

Instructions for adjusting the front glass angle for fixed or fold-down covers.

Operating the Cold Pan

General Operation Information

Basic operational guidance and checking the rating label.

General Cleaning Instructions

Daily cleaning procedures using mild detergent and water.

Polyethylene Cutting Boards Care

Cleaning recommendations for polyethylene cutting boards.

Cold Pan Operating Procedures

Pre-chilling, thermostat setting, and product loading guidelines.

Preventive Maintenance

Condenser Coil Cleaning

Procedure and frequency for cleaning the condenser coil to prevent damage.

Troubleshooting Common Issues

Troubleshooting Guide

Table of common symptoms, causes, and remedies for unit malfunctions.

Customer Service Information

Details for contacting customer service and recording unit information.

Related product manuals

Duke SUB-CP-TC74

Duke SUB-CP-TC48

Preview: Duke SUB-GP