5
(Switch Diagram)
Pause Run Stop
3.2 Initialization Mode
Initialization Mode
1. Hold down the “ALL” button for 5 seconds to display Initialization. Press the
“Run” button to perform initialization. The ticked icon will appear in the upper
left corner of the middle four choices, representing the “ALL” Mode. When you
choose any other button, initialization mode will go off and returns to the
original mode of your operation.
2. Initialization parameter: TPD=850; Direction=bidirectional; Switch =Stop;
Motor Selection=01 group; ALL=ALL selected. Working Hours=24 hours.
3. When you change any of the parameters: Switch - TPD - Direction - Lights,
the initialization mode will exit and the initialization prompt will go off.
(If you have any questions, check out our YouTube video link)
To Next Page
Loading...