6
Tap the "ALL" button 4 times until the top left corner of each of the four
options shows a ticked icon, or Press the "motor selection" and "Run"
buttons at the same time for 5 seconds, and then tap the "Run" button. All
watches will be set to the current mode. . If you change the parameters of
“Switch - TPD - Direction”, all watches will be change to the current
parameters.
(If you have any questions, check out our YouTube video link)
Motor Options:
If the current mode is ALL, just tap the “ALL” button again, the “Motor Options”
will appear, and you can set the mode of each motor individually.
New Watch Mode: Press and hold the "TDP" button until " ----" diagram is
displayed.
Note: During the new watch mode, any operation will cause the new watch
mode to exit and return to the previous settings.
3.3 ALL Mode
Motor Options
3.4 Custom Mode
3.5 New Watch Mode
----
To Next Page
Loading...