To Next PageTo Next Page
Need help?Do you have a question about the Duluth Forge FDF300T and is the answer not in the manual?
Highlights the severe risk of carbon monoxide poisoning and its symptoms.
Provides crucial warnings regarding installation, operation, and proximity of combustibles.
Describes the Oxygen Depletion Sensing (ODS) safety shutoff system.
Details piezo ignition, thermostatic control, and gas options.
Details methods for providing fresh air from adjoining spaces.
Explains how to supply fresh air directly from outside.
Clarifies heater is for supplemental use and provides guidance on circulating air.
Specifies minimum required distances from the heater to surrounding materials.
Instructions for connecting to propane/LP gas, including regulator details.
Instructions for connecting to natural gas, including regulator details.
Details required clearances for facia, sides, back, top, and mantel shelf.
Provides dimensions for framing the rough opening in the wall.
Crucial warnings about qualified technicians, pipe types, and connection safety.
Guidance on pipe size and required components for gas line connection.
Procedure for testing gas supply piping for leaks using specific pressures.
Procedure for testing heater gas connections for leaks after installation.
Step-by-step instructions for immediate actions if a gas leak is detected.
Detailed steps for lighting the pilot light using the ignitor.
Procedure for igniting the main burner after the pilot is lit.
Explains how the thermostat controls the burner based on room temperature.
Instructions for turning off the heater or just the burner.
Details correct and incorrect pilot flame patterns and their implications.
Guidance on inspecting burner flame holes for proper operation and potential blockages.
Procedure for cleaning the pilot air inlet hole and burner assembly.
Addresses issues when the pilot will not light due to gas pressure.
Instructions for bypassing the pressure switch on the regulator for natural gas.
Diagnoses and corrects issues with ignitor spark and pilot flame ignition.
Addresses issues where the pilot flame lights but extinguishes after knob release.
Resolves issues with burner ignition, backfiring, and flame patterns.
Addresses gas odors, smoke, and whistling noises during operation.
Diagnoses heater shutoff (ODS), gas odors, and unwanted odors.
Troubleshoots moisture on windows and clicking/ticking noises.
Information on obtaining replacement parts covered under the product warranty.
Guidance for obtaining replacement parts that are not covered by warranty.
Provides hints for issues arising from low gas pressure.
Details warranty terms for new and factory reconditioned products.
Specifies terms and conditions applicable to all warranty types.
General| Brand | Duluth Forge |
|---|---|
| Model | FDF300T |
| Category | Indoor Fireplace |
| Language | English |
