Duluth Forge FDLR24-1 User Manual

PFS
®
US
WARNING: If the information in this manual is not
followed exactly, a re or explosion may result causing
property damage, personal injury or loss of life.
— Do not store or use gasoline or other ammable va-
pors and liquids in the vicinity of this or any other
appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use any
phone in your building.
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions.
• If you cannot reach your gas supplier, call the re
department.
— Installation and service must be performed by a quali-
ed installer, service agency or the gas supplier.
WARNING: This appliance is equipped for Natural and
Propane gas. Field conversion is not permitted other than
between natural or propane gases.
VENT-FREE GAS LOG
CHASSIS
OWNER’S OPERATION AND
INSTALLATION MANUAL
Questions, problems, missing parts? Before returning to your retailer, call
our customer service department at 1-855-607-6557, 8:00 am - 4:30 pm EST,
Monday through Friday or email info@factorybuysdirect.com
MODELS
FDLR24/30-1

Duluth Forge FDLR24-1 Specifications

General

Heating Capacity	24, 000 BTU
Heating Area	1, 000 sq. ft.
Remote Control	Yes
Ignition System	Electronic Ignition
Thermostat	Yes
Finish	Black
Warranty	1 Year Limited
Type	Ventless Gas Fireplace
Fuel Type	Natural Gas or Liquid Propane
Material	Metal, Glass
Vent Type	Vent-Free

Summary

Safety Guidelines

General Safety Warnings

Important safety precautions for operation, maintenance, and installation.

Air for Combustion and Ventilation

Ventilation Requirements

Details the need for adequate fresh air for proper combustion and ventilation.

Ventilation Air Options

Clearances to Combustibles

Minimum Fireplace Clearances

Noncombustible Material Clearances

Floor and Base Installation

Floor Clearances

Installing Heater Base Assembly

Step-by-step guide for securing the heater base to the fireplace floor.

Gas Selection and Regulator

Connecting to Gas Supply

Gas Piping and Connections

Checking Gas Connections

Pressure Testing Gas Supply

Heater Gas Connection Testing

Operation Safety Before Lighting

Lighting Instructions

Remote Control System

Programming Remote and Receiver

Steps to pair the remote control transmitter with the receiver unit.

Remote Control Settings

Thermostat Mode Operation

Setting desired room temperature and operating in thermostatic mode.

Inspecting Burner Flame Patterns

Pilot Flame Pattern

Correct and incorrect pilot flame patterns and troubleshooting.

Burner Flame Pattern

Care and Maintenance Procedures

ODS/Pilot Maintenance

Cleaning and maintenance of the Oxygen Depletion Sensing pilot assembly.

Burner Injector Holder and Pilot Cleaning

Troubleshooting Introduction

Troubleshooting Ignition and Spark

Pilot Not Lighting (NG)

Causes and solutions when the pilot won't light with natural gas.

Ignitor Spark Issues

Troubleshooting Burner Operation

Pilot Flame Extinguishes

Reasons and solutions when the pilot flame extinguishes after release.

Burner Ignition and Flame Problems

Troubleshooting Operational Issues

Odors, Shutdowns, and Condensation

Diagnosing gas odors, ODS shutdowns, and window condensation.

Parts and Service Information

Replacement Parts

Warranty and Service Support

Details on warranty claims, parts, accessories, service hints, and technical support.

Warranty Information

Keep This Warranty

Factory Buys Direct Limited Warranties

Details of standard and limited warranties for new and reconditioned products.

Terms Common to All Warranties