Dunkirk 95M-200 - Information Mode

Information Mode
See manual 240006104 for complete details on Information Mode.
INFORMATION MODE
Press [MODE] button 2 times from Standby Mode.
(1) Digits after flashing dot show measured outlet temperature.
(2) Digits after flashing dot show -18.
(3) Digits after flashing dot show outside temperature.
(4) Digits after flashing dot show target outlet temperature.
(5) Digits after flashing dot show rate of change in °F per second.
(6) Digits after flashing dot show -32.
NOTE: Display will show A-32 if [STEP] is pressed
after "9" appears.
Display shows Info
Info
then displays Parameter, Flashing Dot,
1.190
until a key is pressed and Current Status.
Press and Hold Key(s) in BOLD
(1)
Duration Result Display
[MODE] [STEP] [STORE] [+] [–] Tap
Step to next
parameter
Measured outlet water temperature
1.180
(First digit shows 1 and dot flashes)
(1)
Return Water temperature
(First digit shows 2 and dot flashes)
(1)
2.150
This function not used
(First digit shows 3 and dot flashes)
(2)
3.-18
Outside temperature
(First digit shows 4 and dot flashes)
(3)
4. 42
This function not used
(First digit shows 5 and dot flashes)
(2)
5.-18
Target outlet water temperature
(First digit shows 6 and dot flashes)
(4)
6.190
Outlet water temp. change over time
(First digit shows 7 and dot flashes)
(5)
7. 1
Return water temp. change over time
(First digit shows 8 and dot flashes)
(5)
8. 1
This function not used
(First digit shows 9 and dot flashes)
(6)
9.-32
12