Need help?Do you have a question about the Durabrand DBTV1301 and is the answer not in the manual?
Be aware of high voltage parts and avoid electric shock.
Use parts with specific safety characters for replacement.
Ensure parts and wiring are returned to original positions.
Handle CRT with care to prevent injury.
Proper repair of HV circuits prevents X-ray emission.
Verify connections, insulation, and safety after repairs.
Step-by-step guide for safely removing the anode cap.
Procedures for removing and installing flat package ICs.
Navigate and modify address/data for EEPROM replacement.
Precautions and tool requirements before performing adjustments.
Adjust RF AGC DELAY to a specific voltage level.
Adjust CUT OFF settings for optimal raster.
Adjust Focus Volume for a distinct picture.
Adjust R.BIAS, R.DRIVE, B.DRIVE, G.BIAS, B.BIAS for white balance.
Adjust tint and color center for proper color reproduction.
Adjust H.PHAS to minimize scan shift.
Adjust V.SIZE to set overscan within ±10%.
Perform initial static convergence using magnets and yoke.
Adjust purity magnets and deflection yoke for correct color centering.
Fine-tune static convergence using 4 and 6 pole magnets.
Adjust dynamic convergence by moving the deflection yoke and inserting wedges.
Lists replacement resistor and diode part numbers.
Lists replacement ICs and transistor part numbers.
Lists replacement capacitor, coil, and transformer part numbers.
To Next Page
General