TROUBLE SHOOTING:
Problem Cause Solution
Motor does
not turn
Battery is not fully charged.
Transmitter battery low.
Motors not connected.
The motor is damaged.
Rec ver is not bound to
Tx.
ESC in set-up mode.
Control surfaces
not moving with
stick input
Model does not
fly straight
Model does not
climb
1. The battery is not fully charged.
2.
Elevator servo is reversed.
3.
CG too far backwards.
Limited Radio
Range
1. Transmitter/ Receiver batteries
are flat.
1. harge/replace batteries.
Model moves
backwards
.dnuora porp eht nruT.1
1. Prop installed backwards
1. The servo lead is connected
to Rx incorrectly.
2.
The servo is damaged.
1. Make sure the servo leads
are connect properly.
2.
Replace servo.
Adjust the trims on the
transmitter.
Re-position o as
suggested.
1. Charge the battery.
2.
Change servo direction
Control surfaces not
centered.
CG is not in the correct position.
via Tx.
3.
Move battery forwards.
Charge the batteries.
Install a full charged battery.
Check for connection
between the ESC and
motor.
Replace motor.
Consult adio manual and
go through bind procedure
again.
Hold model and move
throttle to full pos
tion then
back down to idle.
2. Motor direction reversed
2. Disconnect any two motor
wires from ESC, swap
around and reconnect.
12
To Next Page
Loading...
