DuraLabel BRONCO MAX - Safety Instructions

1 | Safety Instructions GraphicProducts.com | 800-788-5572
Graphic Products
®
, DuraLabel
®
, PathFinder
®
, Toro
®
, Toro Max
®
, Bronco
®
, Bronco Max
®
, Lobo
®
and Kodiak
®
are Registered Trademarks of Graphic Products, Inc. © 2021 Graphic Products, Inc.
SAFETY INSTRUCTIONS
Please review the following safety instructions before using the printer:
• Keep Bronco Max away from extreme humidity (>85%) and prolonged exposure to
direct sunlight.
• Use only with power supply model WDS5150240 (included with the system).
• To completely disconnect power from your Bronco Max, unplug the power supply
from its wall socket and from the Bronco Max printer. The adapter may retain
energy for a short time.
• Do not pour liquids onto the printer or its parts. For ordinary cleaning, follow the
instructions included in this guide.
• Only qualified service personnel should attempt to repair the printer.
• Bronco Max supply may build a small static charge during loading or use.
Do not operate Bronco Max near flammable materials.
NOTE: Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
In addition, to prevent damage to Bronco Max and to avoid nullifying the Bronco Max
warranty, please follow these rules:
• Only use official Bronco Max supplies from Graphic Products in your Bronco Max
printer.
• Read all instructions in this User Guide completely.
For support, please contact Graphic Products by calling 800-788-5572 or visiting
GraphicProducts.com.