Duratech Hot Splash HS35 - Startup and Settings

6
5. Startup and settings
Temp. UP:
Press to increase desired temperature. This menu
will close and save any changes automatically after
5 seconds.
Temp. DOWN:
Press to
reduce desired
temperature. This
menu will close and
save any changes
automatically after
5 seconds.
ON/OFF:
####;5&..#+:&#fI/fll#
button to start the heat
pump. The current water
temperature will appear
and the heat pump will
start automacitally. The
heat pump won’t start
when the desired water
temperature is reached.
Meanwhile the current
water temperature is
shown on the display.
The heat pump will start
automatically when the
water temperature drops
1°C below set point.
####;5&..#+:&#fI/fll#
button to stop the heat
pump.
Operation LED:
The heat pump is equiped with a 150sec
built-in compressor delay to protect control
circuit components. Each time the heat
pump is switched on the countdown is
started and becomes visual on the display.
f%&5*+(-E#OLk#(.#9=(-1(-EU#(-<('*+(-E#+:&#
heat pump isn’t using the compressor at
'755&-+#6,6&-+"#f%&5*+(-E#OLk#(.#*'+(?&U#
indicating the heat pump is using the
compressor at current moment.
Fan LED:
The heat pump is equiped with a
150sec built-in Fan delay to protect
control circuit components. Each time
the heat pump is switched on the
countdown is started and becomes
visual on the display. Fan LED is
9=(-1(-EU#(-<('*+(-E#+:&#:&*+#%76%#(.-@+#
using the fan at current moment. Fan
OLk#(.#*'+(?&U#(-<('*+(-E#+:&#:&*+#%76%#
is using the fan at current moment.
Settings LED:
Set light indicates your
in the settings menu. This
menu will close and save any
changes automatically after 5
seconds.
When settings menu closes
the controller will lock to avoid
*#:*0*5<#.(+7*+(,-"
Ope
Th
bui
cir
pum
sta
f%&
hea
'75
Outdoor socket
Power LED:
Push the reset button on the RCD
of the heat pump. OFF appears on the
<(.%=*DU#(-<('*+(-E#+:&#:&*+#%76%#(.#
supplied by electricity.
Display:
Shows the current water temperature. Following
error messages occure in case of a problem:
J%%&*5.#*+#.+*5+#7%]#J69(&-+#*(5#+&6%&5*+75&#(.#9&=,H#BY_K"
J%%&*5.#H:&-#\&*+#%76%#H*.#*=5&*<D#57--(-E]#(-+&5-*=#:&*+#%76%#
temperature is below 3°C.
One of the heat pump sensors in damaged.
Compressor’s pressure is too high.
Display blinks indicating the controller is locked.
;5&..#+:&#fI/fll#97++,-#!#.&',-<.#+,#7-=,'1#+:&#',-+5,==&5
The Power LED is off while the
:&*+#%76%#(.#57--(-EU#(-<('*+(-E#+:&#
controller is unlocked.