Duratrax 835E - Page 5

5
5
NR
ST
NR
TH
BIND
ST-D/RTH-TRIMST-TRIM
7
7
5
5
RE-BINDING THE TRANSMITTER
TO THE RECEIVER
Your radio system is preset at the factory. If you
need to re-bind your system, follow these steps.
1. Insert the bind plug into
channel 3 on the receiver.
2. Turn on the ESC. The receiver
LED should start blinking.
Receiver LED
Bind Plug
Transmitter
Bind Button
ESC LED
3. Press and hold down the transmitter’s bind button and turn
the transmitter on. The receiver LED will stop blinking.
4. Turn off the ESC and transmitter and remove
the bind plug from the receiver.