Duratrax Evader ST User Manual

Warranty
• DuraTrax
®
will warranty this kit for 90 days after the purchase date from defects in materials or workmanship. DuraTrax
will either repair or replace, at no charge, the incorrectly made part.
• Make sure you save the receipt or invoice you were given when you bought your model! It is your proof of purchase
and we must see it before we can honor the warranty.
• To return your Evader ST for repairs covered under warranty you should send your truck to:
Hobby Services
1610 Interstate Drive
Champaign, Illinois 61822
Attn: Service Department
Phone: (217) 398-0007 9:00 am - 5:00 pm Central Time M-F
E-mail:
hobbyservices@hobbico.com
If the buyer is not prepared to accept the liability associated with the use of this product, the buyer is advised to
return this kit immediately in new and unused condition to the place of purchase.
READ THROUGH THIS MANUAL BEFORE STARTING.
IT CONTAINS IMPORTANT INSTRUCTIONS AND
WARNINGS CONCERNING THE ASSEMBLY AND USE
OF THIS MODEL.
© Copyright 2001 DTXZ3100 For Kit DTXC0020/DTXD20**
ASSEMBLY AND OPERATION MANUAL
®
Length: 15.2" [385mm]
Width: 13" [330mm]
Height: 5.8" [147mm]
Weight: 3 lbs 6.3 oz
Wheelbase: 11.6" [295mm]
Motor: Photon Speed
™
20 Turn
Radio: 2-channel surface frequency
®
1610 Interstate Drive Champaign, IL 61822
(217) 398-8970, Ext. 2
carsupport@duratrax.com
™

Duratrax Evader ST Specifications

General

Brand	Duratrax
Model	Evader ST
Category	Motorized Toy Car
Language	English

Summary

Introduction

Important Safety Precautions

Helpful Hints

Safety Precautions

Stress-Tech Parts Guarantee

Repair Service

Required Items for Completion

Tools Needed for Completion

Tools Included for Maintenance and Cleaning

Finishing the Evader ST RTR Version

Finishing the Evader ST Pre-Built Version

Preparing the Radio System

Guides the user through setting up the transmitter, receiver, servo, and ESC for operation.

Charge Your Battery

Instructions on how to properly charge the vehicle's battery pack.

Steering Servo Installation

Receiver Installation

Electronic Speed Control Set Up

Maintenance Tips

Ball Differential Break-In

Procedure for breaking in and adjusting the ball differential for optimal performance.

Before Each Run

Checklist of essential inspections to perform on the Evader ST before each use.

After Each Run

Steps to take for cleaning and basic checks after operating the Evader ST.

After Every 10 Runs

Detailed maintenance checks and procedures recommended after approximately ten runs.

Assembly Guide

Tuning Guide

Caster

Explanation of caster angle and its adjustability in the Evader ST.

Camber

Details on camber angle, its effect on handling, and adjustment methods.

Front Toe-In and Toe-Out

Wheel Base

Battery Placement

Ride Height

Camber Link Placement

Slipper Adjustment

Front Shock Adjustment

Rear Shock Adjustment

Shock Oils and Shock Springs

Steering Dual Rate