7
BODY INSTALLATION
• Decal the body to your liking. Use the
photos on the box as a reference.
• Install the body onto the chassis using
four body clips.
MAINTENANCE
TIPS
BEFORE EACH RUN
• IMPORTANT: Check to make sure
that all screws are tight. Always use
threadlock (DTXR2010) on screws
going into metal.
• Before running always check the condition of your radio
system batteries and replace/recharge if necessary.
• Check to make sure that all of the moving parts of the
Vendetta TC move freely and do not bind.
• Before running, turn on the radio and make sure the servos
move easily and in the proper direction.
• Check for any broken or damaged parts. Replace them before
running the Vendetta TC. Running the Vendetta TC with
broken or damaged parts could damage additional parts.
• Check to make sure that all wires are properly connected.
• Check that the ESC and receiver are properly secured to
the chassis.
AFTER EACH RUN
• Clean any debris from the chassis and moving parts.
• Check for any broken or damaged parts. Replace them
before the next run.
• Disconnect and remove the battery from the chassis.
AFTER EVERY 10 RUNS
• Check to make sure that the bearings are free of dirt and
debris, and roll smoothly.
• Check the shocks for oil leakage. Inspect the shaft and
O-rings for wear and damage. Replace if necessary. (A
shock shaft with scratches you can feel with a fingernail
should be replaced.)
• Check the tires to make sure they are still properly glued
to the wheels.
To Next Page
Loading...
