6
SPEED CONTROL SET UP
• The Vendetta TC ESC is an auto-set ESC.
• Lift the chassis off the ground during the ESC set up.
• Center the throttle trim knob on the transmitter.
• Connect the battery pack to the ESC. Turn on the Tx,
and then the ESC.
• Wait 2 seconds and then quickly pull the trigger to full
throttle and release.
• The ESC is now set up.
• Raise the antenna.
• Turn the transmitter on. Then turn the receiver on.
• Turn the transmitter wheel to the right—the front
wheels should turn to the right. If not, move the
steering servo reverse switch.
• When running, adjust the steering trim so the car
tracks straight.
• Gently pull back on the throttle trigger. The Vendetta
TC should slowly move forward. If the car goes in
reverse, move the throttle reversing switch on the
transmitter. The throttle trim knob may also need to
be adjusted to find neutral.
ALWAYS CHECK THE RADIO
OPERATION BEFORE EACH RUN
!
Forward
Reverse
Throttle
Tr i m
Steering
Tr i m
Steering
Servo
Reverse
Switch
On/Off
Throttle
Servo
Reverse
Switch
RADIO SYSTEM CHECK
To Next Page
Loading...
