L C P Min Max Preset Unity Description
t 00 36 0 6000 500 rpm Wished speed reduction when shifting the feed dog.
t 00 40 0 2 1 - Type of the start backtack, if the backtacking is toggled.
0 = Simple start backtack;
1 = Double start backtack;
2 = Start multiple backtack
t 00 41 0 2 1 - Type of the end backtack, if the backtacking is toggled.
0 = Simple end backtack;
1 = Double end backtack;
2 = End multiple backtack
t 00 44 0 3 3 - Mode of the manual backtack
0 = Manual backtack switched immediately;
1 = Manual backtack switched according to parameter
t 00 45 und t 00 46;
2 = If the manual backtack is pressed, the motor will stopped
in the position according to parameter t 0045 und t 00 46;
3 = If the manual backtack is pressed, the motor will stopped
in the position according to parameter t 0045 und t 00 46;
(Only with the parameter t 00 30 = 1)
t 00 45 0 1 0 - Switching on the manual backtack
0 = Needle below;
1 = Needle above
t 00 46 0 1 0 - Turning the manual backtack off
0 = Needle below;
1 = Needle above
t 00 50 0 999 100 ms Drive time of the backtack magnet in the time period t
1
t 00 51 5 100 100 % Pulse duty ratio in the time period t
1
t 00 52 0,0 600,0 100,0 s Drive time of the backtack magnet in the time period t
2
(If you adjust 0s the backtack magnet will be driven
permanently)
t 00 53 5 100 40 % Pulse duty ratio in the time period t
2
t 00 54 0 1 1 - Increasing U
mag
when the backtack magnet will be driven
0 = No;
1 = Yes
To Next Page
Need help?
General
