Installation Manual
SBB816V
Rev. 05/19
To be installed and serviced only by an authorised person.
This appliance is not suitable for use as a pool heater.
The “authorised installing person” is responsible for:
1. Correct commissioning of this appliance
2. Ensure unit performs to the specification stated on the data label
3. Demonstrate operation of unit to customer before leaving
4. Hand these instructions to customer
This appliance must be installed in accordance with the manufacturer’s installation instructions all Local Building,
Water and Gas fitting regulations (AS/NZS 3500.4, AS/NZS 5601, AS/NZS 3000).
Failure to install this appliance in accordance with these installation instructions may void warranty.
In the interest of continued product improvement, Dux Manufacturing reserves the right to alter these
specifications without notice.
(e.g. 26ECB5N)
Condensing Models
26ECB5N
26ECB5L
26ECB6N
26ECB6L
21ECB5N
21ECB5L
21ECB6N
21ECB6L
Non Condensing Models
21ENB5N
21ENB5L
21ENB6N
21ENB6L
17ENB5N
17ENB5L
17ENB6N
17ENB6L
26ENA5N
26ENA5L
26ENA6N
26ENA6L
32END5N
32END5L
32END6N
32END6L
AU Service Department : 1300 365 115
NZ Service Department : 0800 729 389
For continued safety of this appliance it must be
installed, operated and maintained in accordance with
the manufacturer’s instructions.
WARNING
SBB816V工説GQ-C2434WS DU#B.indd 1 2019/11/12 11:57:59
To Next Page
Need help?
General
