949-1239-3 2 Rev. 10/98
TABLE OF CONTENTS
GETTING STARTED .............................................................................. 2
INSTALLATION....................................................................................... 4
DIMENSIONS ......................................................................................... 5
INPUT SELECTION ................................................................................ 5
LOGIC JUMPER SELECTION................................................................ 6
WIRING................................................................................................... 7
FRONT PANEL KEY FUNCTIONS......................................................... 8
NOTATION CONVENTIONS FOR THE MENUS ................................. 10
THE HOME DISPLAY ........................................................................... 10
OPERATION OF SELF TUNE® FUNCTION ........................................ 11
Theory of Operation ..................................................................... 11
Program Setup and Operation .................................................... 12
METHOD FOR SET UP OF A HEAT / COOL CONTROL WITH SELF
TUNE .................................................................................................... 12
PROGRAMMING AND OPERATION FOR RAMP / SOAK FEATURE 13
Theory of Operation ..................................................................... 13
Program Setup .............................................................................. 13
Ramp / Soak Operation ................................................................ 14
MENU SELECTIONS ........................................................................... 15
PRIMARY MENU .................................................................................. 15
SECONDARY MENU ............................................................................ 15
SECURE MENU.................................................................................... 21
DIAGNOSTIC ERROR MESSAGES .................................................... 28
CONFIGURATION MENU .................................................................... 30
SPECIFICATIONS ................................................................................ 35
GETTING STARTED
1. Install the control as described on page 4.
2. Make sure that the Input DIP switch is set correctly for the input
you wish to use. Instructions on page 5.
3. If you wish to use the Logic (5 VDC) output, make sure that the
Logic jumper is in the correct position. See page 6 for details.
4. Wire your control following the drawing on page 7.
5. Make any programming changes necessary first in the Secure
Menu (page 21), next in the Secondary Menu (page 15), and
finally in the Primary Menu (page 15). DO NOT make changes to
the Configuration Menu unless specifically instructed. If you need
to back up in a menu, press the INDEX and DOWN ARROW keys
together.
To Next Page
Loading...
Need help?
General
