dymax EC Series - Power Cord Connection

10
Dymax EC-Series Flood Lamps for UVCS Conveyors User Guide
Figure 9. Interconnect Cable in J3 Receptacle (From Left: 2000-EC, 5000-EC for
SideCure™ Conveyors, and 5000-EC
4. Connect the opposite end of the Interconnect Cable to the Lamp Power Receptacle (Figure 10) on
rear panel of the Power Supply.
5. Plug the AC Power Cord into the Power Module located in the rear panel of the Power Supply (Figure
10), and plug the opposite end of the AC Power Cord into appropriate external AC source.
Figure 10. Power Supply, Rear Panel
Lamp Power Receptacle
Power Module