Need help?Do you have a question about the Dymo Hobbyist and is the answer not in the manual?
General| Power Source | Battery (2 AA batteries) |
|---|---|
| Display | LCD |
| Tape Type | D1 |
| Keyboard | Yes |
| Label Width | 9 mm |
| Label Type | D1 |
Set tape width, insert tape cartridge, and advance tape by clicking the handle.
Select letters, print, advance tape, and cut the label using the white button.
Peel off the backing strip and firmly press the label into place.
Pull white wheel pin, remove old wheel, slide in new one, release pin.
