Dyna-Glo DGH485CRP User Manual (English)

Questions and Answers:

J
Jerry CameronAug 5, 2025
What to do if Dyna-Glo DGH485CRP Grill burner will not light with a match?
- K
  katherinerosalesAug 5, 2025
  If the burner on your Dyna-Glo grill won't light with a match, there are several potential causes. First, ensure the match is reaching the burners by using the match holder found in the cabinet door. Also, check the fuel level and refill the tank if it's empty. A poor connection between the valve regulator and LP cylinder coupling could also be the issue; turn off the grill knobs, close the LP cylinder valve, and check the connection, disconnecting and reconnecting if necessary. Finally, the burner inlet may be blocked, so clean the burner inlet (venturi) and burner as described by the Care and Maintenance section in the manual.
C
cunninghamchristopherAug 13, 2025
Why is there no gas flow in my Dyna-Glo DGH485CRP Grill?
- R
  Raymond RiveraAug 13, 2025
  If you're experiencing no gas flow or an obstructed gas flow in your Dyna-Glo Grill, there are several possible reasons. The tank valve may not be on or fully opened, so fully open the tank valve by turning it counterclockwise. Also, the tank might be empty, so check the fuel level and replace the fuel if necessary. A poor connection between the valve regulator and LP cylinder coupling could also be the problem; turn off the grill knobs, close the LP cylinder valve, and check the connection, disconnecting and reconnecting if needed. Lastly, the burner inlet could be blocked, so clean the burner inlet (venturi) and burner as described by the Care and Maintenance section in the manual.
S
Sharon MartinAug 21, 2025
How to fix Dyna-Glo DGH485CRP igniter that won't light?
- E
  Elizabeth BenjaminAug 21, 2025
  If your Dyna-Glo Grill burner won't light using the igniter, and there's a weak or no spark, it could be due to a few reasons. The igniter electrode may be covered with grease or residue, so clean the igniter electrode. Also, the igniter electrode may have a loose or disconnected wire, so check the connection and reconnect any loose or disconnected wires. In some cases, the ignition electrode may be cracked or broken, in which case you should replace it (see Replacement Parts List).
J
jenniferbowmanAug 28, 2025
Why does my Dyna-Glo DGH485CRP Grill have excessive flare ups?
- H
  hellisAug 28, 2025
  Excessive flare-ups in your Dyna-Glo Grill can occur due to several reasons: a build-up of grease and/or residue on heat tents or in the firebox, excessive dripping of fat or marinade from food, or a cooking temperature that is too high. To resolve this, clean the grill components, trim the fat from meat and use non-oil based marinades, and lower the cooking temperature accordingly.

Dyna-Glo DGH485CRP Specifications

General

Brand	Dyna-Glo
Model	DGH485CRP
Category	Grill
Language	English

Summary

Safety Information

DANGER

General safety warnings for hazardous situations, including explosive atmospheres and flammables.

CAUTION

Safety precautions for potential minor hazards like using charcoal fluid or storing cylinders.

Safety Information

WARNING

Important warnings regarding grill placement, clearances, and unattended use.

CAUTION

Additional safety precautions for operation, including avoiding flammable liquids and securing casters.

Package Contents

Parts Identification

List of all parts included in the grill package with descriptions and quantities.

Hardware Contents

Hardware Identification

List of hardware components, quantities, and specifications for assembly.

Preparation

Assembly Preparation

Preliminary steps before assembly, including parts check and estimated assembly time.

Assembly Instructions

Bottom Panels Assembly

Instructions for assembling the bottom panels of the grill.

Right Side and Rear Panels Assembly

Instructions for attaching side and rear panels to the grill base.

Assembly Instructions

Rear Panel Assembly

Instructions for attaching the rear panel to the grill assembly.

Left Side and Rear Panels Assembly

Instructions for attaching the left side and rear panels.

Assembly Instructions

Casters Assembly

Instructions for attaching the grill casters for mobility.

Cylinder Exclusion Assembly

Instructions for installing the cylinder exclusion component.

Assembly Instructions

Upper Brace and Cabinet Magnet Assembly

Instructions for attaching the upper brace and cabinet magnet.

Doors Assembly

Instructions for attaching the grill doors.

Assembly Instructions

Handle, Knobs, and Temperature Gauge Assembly

Instructions for installing the handle, knobs, and temperature gauge.

Grill Body to Base Assembly

Instructions for attaching the grill body to the base.

Assembly Instructions

Left Side Table and Condiment Tray Assembly

Instructions for attaching the left side table and condiment tray.

Assembly Instructions

Right Side Shelf Assembly

Instructions for attaching the right side shelf.

Assembly Instructions

Side Burner Assembly

Instructions for installing the side burner.

Assembly Instructions

Optional Smoker Box Assembly

Instructions for installing the optional smoker box.

Heat Tents Assembly

Instructions for installing the heat tents.

Assembly Instructions

Rack and Cooking Grates Assembly

Instructions for installing racks and cooking grates.

Grease Pan and Grease Cup Assembly

Instructions for installing the grease pan and cup.

Assembly Instructions

Propane Cylinder Installation

Instructions for installing the propane cylinder.

Operation Instructions

Checking for Leaks

Procedures for checking gas leaks before operation.

Performing Leak Test

Detailed steps for conducting a leak test using soap solution.

Operation Instructions

Connecting Gas Cylinder

Guidelines for connecting the propane gas supply cylinder, including specifications.

Operation Instructions

Connecting the LP Tank

Step-by-step instructions for securely connecting the LP tank to the regulator.

Operation Instructions

Lighting the Grill

Instructions for initial lighting, cleaning burn-off, and basic operation.

Cooking Guide

Guidance on adjusting burners for desired cooking temperatures and searing.

Operation Instructions

Lighting with a Match

Procedures for lighting the grill using a match if the igniter fails.

Shutdown Instructions

Steps for safely shutting down the grill after use.

Care and Maintenance

Cleaning Procedures

Instructions for cleaning grates, heat tents, grease cup, and exterior surfaces.

Flame Inspection

Guidance on checking the burner flame for optimal performance and safety.

Care and Maintenance

Removing the Burner Assembly

Steps for safely removing the main and SearPLUS™ burners from the firebox.

Care and Maintenance

Cleaning the Burner Assembly

How to clean the burner assembly, ensuring ports are clear of clogs.

Re-installing the Burner

Procedures for correctly reinstalling burners and ignition wires.

Other Care and Maintenance

Recommendations for annual service and regular checks of ventilation and parts.

Troubleshooting

Ignition and Flame Problems

Addresses igniter issues, low heat, flare-ups, and match lighting problems.

Gas Flow Issues

Solutions for no gas flow or obstructed gas flow.

Limited Warranty

1-Year Limited Warranty

Details of the one-year limited warranty for the grill, including exclusions.

Replacement Parts Diagram

Parts Identification Diagram

Exploded view diagram identifying grill components by number.

Replacement Parts List

Parts List Details

Detailed list of grill parts, their descriptions, and part numbers.

Replacement Parts List Continued

Continued Parts List

Continuation of the detailed list of grill parts and their part numbers.

Related product manuals

Dyna-Glo DGH485CRP User Manual

Table of Contents

Questions and Answers:

Dyna-Glo DGH485CRP Specifications

Summary

Safety Information

DANGER

CAUTION

Safety Information

WARNING

CAUTION

Package Contents

Parts Identification

Hardware Contents

Hardware Identification

Preparation

Assembly Preparation

Assembly Instructions

Bottom Panels Assembly

Right Side and Rear Panels Assembly

Assembly Instructions

Rear Panel Assembly

Left Side and Rear Panels Assembly

Assembly Instructions

Casters Assembly

Cylinder Exclusion Assembly

Assembly Instructions

Upper Brace and Cabinet Magnet Assembly

Doors Assembly

Assembly Instructions

Handle, Knobs, and Temperature Gauge Assembly

Grill Body to Base Assembly

Assembly Instructions

Left Side Table and Condiment Tray Assembly

Assembly Instructions

Right Side Shelf Assembly

Assembly Instructions

Side Burner Assembly

Assembly Instructions

Optional Smoker Box Assembly

Heat Tents Assembly

Assembly Instructions

Rack and Cooking Grates Assembly

Grease Pan and Grease Cup Assembly

Assembly Instructions

Propane Cylinder Installation

Operation Instructions

Checking for Leaks

Performing Leak Test

Operation Instructions

Connecting Gas Cylinder

Operation Instructions

Connecting the LP Tank

Operation Instructions

Lighting the Grill

Cooking Guide

Operation Instructions

Lighting with a Match

Shutdown Instructions

Care and Maintenance

Cleaning Procedures

Flame Inspection

Care and Maintenance

Removing the Burner Assembly

Care and Maintenance

Cleaning the Burner Assembly

Re-installing the Burner

Other Care and Maintenance

Troubleshooting

Ignition and Flame Problems

Gas Flow Issues

Limited Warranty

1-Year Limited Warranty

Replacement Parts Diagram

Parts Identification Diagram

Replacement Parts List

Parts List Details

Replacement Parts List Continued

Continued Parts List

Related product manuals