To Next PageTo Next Page
Need help?Do you have a question about the Dyna-Glo KFA80DGD and is the answer not in the manual?
General| Model | KFA80DGD |
|---|---|
| Heater Type | Forced Air |
| Fuel Type | Kerosene |
| BTU Output | 80, 000 BTU |
| Thermostat | No |
| Heating Area | 1, 900 sq. ft. |
Proper ventilation is crucial to prevent health risks from combustion byproducts.
Avoid fuel misuse, flammable vapors, and hot refueling to prevent fire hazards.
Ensure proper electrical connections and avoid water exposure for safety.
K1 Kerosene is recommended; other fuels like diesel and Jet A are acceptable.
Safety feature to prevent overheating by shutting off the heater.
Ensure adequate ventilation and follow steps to start the heater.
Clean photocell annually; replace if necessary following specific steps.
Adjust pump pressure using the relief valve on HIGH BTU setting.
Procedure to safely inspect and replace the fuse if the heater fails to ignite.
Addresses issues like wrong pump pressure, dirty filters, or bad connections.
Covers no fuel, spark plug issues, blown fuse, or connection faults.
Diagnoses low thermostat settings, sensor failures, or bad connections.
