NEVER LEAVE THE HEATER
UNATTENDED WHILE BURNING!
11
12.
Snug 4 wing nuts on the
mounting stud, but do not
tighten.
14.
Check height of wick.
It should be 5/16” above collar
13.
Raise the wick to the full “up”
position, and evenly tighten
wing nuts in several steps.
18. Fasten the Cabinet & Grill
assembly to the heater with 3
screws. Replace the Wick-
Adjuster Knob and ignition Knob
to the heater.
15.
Check for correct clearance
between wick holder and draft
tube. It should be the same all
around.
17. Tilt the Cabinet & Grill assembly
slightly using both hand and
replace on heater from front to
rear.
16.
Check the function of safety
shut-off mechanism by
pushing the extinguish button
to upset the pendulum.
5/16”
To Next Page
Loading...
