dynabook TECRA A40-J - Installing the Fans; Removing the Fin

S2 x 4CT
Fan Harness
Fan
CN3380
CN3390
Figure 4-21 Removing the Fans
4.18.2 Installing the Fans
To install the Fans, follow the steps below and refer to Figure 4-21.
1. Set the Fans in place on the Cover Assembly and secure them with the
screws.
2. Connect the Fan harness to the connector CN3380 and CN3390 on
the System Board (FMERSY*).
4.19 Fin
4.19.1 Removing the Fin
To remove the Fin, follow the steps below and refer to Figure 4-22.
1. Remove the following screws and then the Fin.