dynabook TECRA A40-J - Removing the Battery Pack

Take care not to short circuit the terminals when removing the battery
pack. Similarly, do not drop, knock, scratch, disassemble, twist, or bend
the battery pack.
Figure 4-5 Removing the Base Assembly (2)
4 2
1
Base Assembly
2 3
Cover Assembly
4.12.1 Removing the Battery pack
To remove the battery pack, follow the steps below and refer to Figure 4-7
and Figure 4-8.
1. Disconnect the BATTERY HARNESS from the connector CN8021 on
the SYSTEM board.
2. Remove the following screws and the battery pack
3. Disconnect the BATTERY HARNESS from the connector on the battery
pack.