Take care not to press on the top or bottom of a SSD. Pressure may cause
the data loss or damage to the device.
2. Removing the SSD
Please refer to the information below for the removal of the SSD.
One Philips screwdriver with type 1 bit will be required to remove the screws indicated in the
locations below. Once removed, these components should be recycled as per local
requirements.
4.14.1
Removing the SSD
To remove the SSD, follow the steps below and refer to Figure 4-11.
1. Remove the the following screw and disconnect the SSD from the
connector CN1900 on the SYSTEM board.
Figure 4-11 Removing the SSD
To Next Page
Loading...
