dynabook TECRA A40-J - Page 21

CN9510
CN9550
Click Pad FFC
1
Fingerprint
FFC
2
A
AL
T
T
A
A
P
P
E
C
C
l
l
i
i
c
c
k
P
P
a
a
d
1. Disconnect the Click Pad FFC and Fingerprint FFC from the
connectors on the Click Pad and the connectors CN9510 and CN9550
on the System Board.
Figure 4-23 Removing the Click pad (1)
2. Peel off the AL TAPE from the Click Pad and then peel off the Click
Pad from the Cover Assembly.
Figure 4-24 Removing the Click pad (2)
4.20.2 Installing the Click pad
To install the Click pad, follow the steps below and refer to Figure 4-23 to
Figure 4-25.
1. Stick the Click Pad FACE SHEET to a new Click Pad.
2. Peel off the separator on the Click Pad RIM ASSY and stick the new
Click Pad to the Cover Assembly.