dynabook TECRA A40-J - Page 7

7
6
3
2
4
9
9
8
5
5
1
M2.5 x 5BT
4.11 Cover Assembly and Base Assembly
4.11.2 Removing the Cover Assembly and Base Assembly
To remove the Base Assembly, follow the steps below and refer to Figure 4- 4
to Figure 4-5.
1. Close the display panel and turn the computer face down.
2. Remove the following screws securing the Cover Assembly and the
Base Assembly.
Figure 4-4 Removing the Base Assembly (1)
3. Separate the Base Assembly and Cover Assembly while releasing
the latches using a plectrum.