dynabook TECRA A50-J - Battery Pack

Take care not to short circuit the terminals when removing the battery pack.
Similarly, do not drop, knock, scratch, disassemble, twist, or bend the battery pack.
CN8021
Battery Harness
S2x4CT
4.12 Battery pack
4.12.1 Removing the Battery pack
To remove the battery pack, follow the steps below and refer to Figure 4-7 and Figure 4-8.
1. Disconnect the BATTERY HARNESS from the connector CN8021
on the SYSTEM board.
2. Remove the following screws and the battery pack.
Figure 4-7 Releasing the battery pack (1)
3. Disconnect the BATTERY HARNESS from the connector on the
battery pack.