dynabook TECRA A50-J - Usb Board

4.24 DC IN jack
4.24.1 Removing the DC IN jack
To remove the DC IN jack, follow the steps below and refer to Figure 4-34.
1. Release three screws securing the right display hinge and rotate
the display hinge to upright position.
2. Release the DC IN jack harness from the guide, and remove the DC
IN jack from the slot on the Cover Assembly.
Figure 4-34 Removing the DC IN jack
DC IN jack harness
4.24.2 Installing the DC IN jack
To install the DC IN jack, follow the steps below and refer to Figure 4-34.
1. Set the DC IN jack to the slot on the Cover Assembly and arrange
the DC IN jack harness to the guide.
2. Rotate the right display hinge to original position and secure it
with three screws.
4.25 USB board
4.25.1 Removing the USB board
To remove the USB board, follow the step below and refer to Figure 4-35.
1. Release three screws securing the left display hinge and rotate
the display hinge to upright position.
2. Remove the following screws and the USB board from the
Cover Assembly.