4.15
Smart Card slot
4.15.1
Removing the Smart Card slot
To remove the Smart Card slot unit, follow the steps below and refer to Figure 4-13 to
Figure 4-16.
1. Disconnect the FPC/FFC from the connector CN9600 on the
SYSTEM board and CN9640 on the USB board.
Figure 4-13 Removing the Smart Card slot (1)
2. Peel off the INSU CUSHION SC from the Smart Card slot.
Figure 4-14 Removing the Smart Card slot (2)
3. Disconnect the Smart Card FFC from the connector CN2170 on the
system board.
To Next Page
Loading...
