dynabook TECRA A50-J - Page 16

CN2170
S2x2BT
Smart Card Slot FFC
Smart C rd Slot
1
2
4. Remove the following screw and peel off the AL TAPE. Then slide and
lift the Smart Card slot unit shown in the following figure to remove the
Smart Card slot.
Figure 4-15 Removing the Smart Card slot (3)
5. Disconnect the Smart Card FFC from the connector on the Smart
Card slot.
Figure 4-16 Removing the Smart Card slot (4)
4.15.2 Installing the Smart Card slot
To install the Smart Card slot, follow the steps below and refer to Figure 4- 13 to
Figure 4-16.
1. Connect the Smart Card FFC to the connector on the Smart Card slot.