DYNACO Dynakit ST35 User Manual

\
2
CONTENTS
3
General Wiring Practice •...••.. :. 4
• • '" I
Mechanical Assembly; .... : .. ". . . • •. 5
Wiring Instructions 6
240·Yolt Transformers " . .. 9
Installation 9
In Case of Trouble . . . . . . . . . . . . . .. 10
Parts list ".. 11
Schematic Diagram Back Cover
SPECIFICATIONS
Power Output: 35 watts continuous, 45 watts
IHF Music Power (both channels)
Frequency Response: ± 1 db from 10 cps to 40,000 cps.
Power Response: 20 cps to 20,000 cps without
exceeding 1% distortion within
1 db of 17.5 watts each channel
Intermodulatlon Distortion: Less than 1% at 17.5 watts each
channel. Less than 0.1 % at
average listening levels.
Hum and Noise: Inaudible; more than 80 db below
rated output.
Sensitivity: 1 volt input for 17.5 watts out-
put (each channel).
-'
Input Impedance: 500,000 ohms.
Output Impedance: 8 and 16 ohms.
Damping factor: 10 from 20 cps to 20,000 cps.
Minimum Channel Separation: 80 db.
Power Consumption: 100 watts, 50/60 cycle a.c.
Tube Complement: 7247 (2), 6BQS/EL84/7189 (4),
silicon diodes (2).
Size: 4// high, 13" wide, SW' deep.
Shipping weight: 16 lbs.
~
\ .J
\,

DYNACO Dynakit ST35 Specifications

General

Brand	DYNACO
Model	Dynakit ST35
Category	Amplifier
Language	English