Need help?Do you have a question about the DYNACO Stereo 120 and is the answer not in the manual?
Defines the required skills and helpful knowledge for undertaking the project.
Lists the necessary tools for performing the upgrade.
Outlines the main steps involved in the power supply modification project.
States the manufacturer's right to change components without prior notification.
Specifies the type and diameter of solder recommended for the project.
Details the initial steps to safely open the amplifier for modification.
Steps to detach the PSUG and original heatsink assembly and then separate them.
Guides on replacing three specific components to enhance power output.
Describes drilling a new hole in the chassis for mounting the upgraded assembly.
Details attaching the PSUG to the new heatsink with thermal compound.
Instructions for installing the modified assembly back into the amplifier chassis.
Advises checking for any interference or loose parts after installation.
Explains how to test the amplifier's output voltage after the upgrade.
Guides on completing the reassembly of the amplifier.
Defines the required skills and helpful knowledge for undertaking the project.
Lists the necessary tools for performing the upgrade.
Outlines the main steps involved in the power supply modification project.
States the manufacturer's right to change components without prior notification.
Specifies the type and diameter of solder recommended for the project.
Details the initial steps to safely open the amplifier for modification.
Steps to detach the PSUG and original heatsink assembly and then separate them.
Guides on replacing three specific components to enhance power output.
Describes drilling a new hole in the chassis for mounting the upgraded assembly.
Details attaching the PSUG to the new heatsink with thermal compound.
Instructions for installing the modified assembly back into the amplifier chassis.
Advises checking for any interference or loose parts after installation.
Explains how to test the amplifier's output voltage after the upgrade.
Guides on completing the reassembly of the amplifier.
General| Frequency Response | 20Hz to 20kHz |
|---|---|
| Weight | 18 lbs |
| Type | Solid State |
| Power Output | 60 watts per channel into 8 ohms (stereo) |
| Speaker Load Impedance | 4Ω to 16Ω |
To Next Page
