DYNACO Stereo 120 - Figure 5-Layout for Added Mounting Hole; Figure 6-Screw Sizes to Mount PSUG, Remember to Tighten the Screws

Page 8 of 10
a. Use the 6-32x3/8” screw from the previous mounting arrangement to
fasten the power MOSFET to the heatsink.
b. Use the supplied 6-32x1/4” sem screws (with built-in lockwashers) to
fasten the PSUG to the really big heat sink.
Figure 5-layout for added mounting hole
Figure 6-screw sizes to mount PSUG, remember to tighten the screws