Need help?Do you have a question about the DYNACO SCA-80Q and is the answer not in the manual?
Details on upgrading the SCA80C9 kit for improved bass and reduced distortion.
Lists required skills and helpful knowledge for attempting the assembly project.
Lists necessary tools for assembling the replacement power supply kit.
Outlines the main steps involved in building and installing the new power supply.
States the manufacturer's right to change designs or components without prior notice.
Specifies the type and diameter of solder recommended for kit assembly.
Suggests using a soup bowl to hold and organize electronic components during assembly.
Provides instructions on how to install resistors onto the printed circuit board.
Explains resistor specifications, K notation, and orientation guidelines.
Details the process of installing the diode, emphasizing correct polarity alignment.
Guides the installation of the TO-92 package voltage regulator, noting lead adjustment.
Instructions for installing the TO-220 package voltage regulator with a heat sink.
Instructions for installing polarized electrolytic capacitors, stressing polarity alignment.
Describes how to insert and solder a wire into the GJ1 terminals on the PCB.
Provides steps for safely disconnecting and removing the existing power supply components.
Details the process of attaching mounting brackets and installing the new power supply PCB.
Explains how to strip wires and make power connections to the new power supply board.
Guides on inspecting work, plugging in, and measuring output voltages for verification.
To Next Page
General
