IPX Series DSP Multichannel Networking Power
Amplifier
Installation | en 13
Bosch Security Systems, Inc. Installation manual 2018.04 | 01 | F.01U.330.705
Figure5.1: Power amplifier ventilation
Caution!
Blocking/closing the power amp's ventilation louvers is not permissible. Without sufficient
cooling/ventilation, the power amplifier may enter protect mode.
Keep ventilation louvers free from dust to ensure unhindered airflow.
Notice!
Do not use the power amplifier in direct sunlight or near heat sources, like heater blowers,
stoves, or any other heat radiating devices.
Notice!
Do not use the power amplifiers in an environment where temperatures are below 5 °C (41
°F) or exceed +40 °C (104 °F).
For fixed amplifier installations in a device control room that incorporate a central air-cooling
system or air conditioners, calculating the maximum heat emission may be necessary.
See also
– Mains operation & resulting temperature, page 28
To Next Page
Loading...
